INSTRUCTION MANUAL FOR
HEATED MITTS/GLOVES WITH 3 TEMPERATURES SETTINGS
MITTS/GLOVES SPECIFICATIONS

Battery Specifications

Material of the Gloves
• Outlayer: windproof, waterproof & breathable fabric + PU
    Lining: cotton
• Heating material: composite fiber

Read these instructions carefully before using these gloves

FEATURES
• Touch screen compatible thumbs.
• Built-in heating elements extended along the entire back of the hands procures even heat distribution.
• Three different heating settings by pressing the LED button indicate the level of warmth: Red color for high intensity, Blue color for medium intensity, Green color for low intensity.
• The built-in “charging-discharging” protection device provides a sager and more reliable quality to the lithium battery, lasting for 300 to 500 recharge cycles.

FIRST USE AND CHARGING THE BATTERIES
The batteries must be fully charged in 12 hours before using the for the first time. Afterwards, charging time is approximately 5 to 6 hours.
• Connect the battery packs to the charger. Plug the charger into an electrical outlet by selecting the correct country-specific adapter. The charge indicator will light up red while charging, the charge indicator will turn green when the batteries are fully charged; (specially specified: the LED light on the battery is always red while charging, and the color won’t be changed. It is just indicator for charging.)
• Remove both battery packs from the charger.
• Open the battery pocket of the gloves, align the connectors, and plug the battery packs to the glove heating system’s wires.
• Carefully place the battery packs and the wires back into the battery pocket and close it.
• Make sure the batteries have been connected correctly to the gloves and that the connection is latched.

USE AND COTROLLING TEMPURATURE
• Turning on : After aligning the connectors between the battery pack and the gloves will do self-checking by flashing from RED, WHITE and BLEU, ten self-checking is done.
• Press the ON/OFF switch for 2-3 seconds, RED light comes to show the gloves are in 1st heat setting and it will gently heat up in 1 minute. If no operation on the switch, it will automatically swift to 2nd heat setting and WHITE light is on (Note: if press ON/OFF switch within 5 minutes, the light will turn WHITE, the gloves are in 2nd heat setting.
• Press 0N/OFF switch again, when WHITE light on, the gloves are in 3rd heat setting.
• Press ON/OFF switch again, when RED light on, the gloves are in 1st heat setting.
• Turning off: To turn off the gloves system, press ON/OFF switch for 2-3 seconds and light will go off.
If feel cold after the gloves in heating mode, the battery should be out of power. Please use it after re-charged.

WORKING TIME
Testing temperature is based on 20°C, if the temperature goes lower, battery working time goes shorter and temperature becomes lower than below indications;

SAFETY PRECAUTIONS
• Please turn off the switch when not use. Please hold the plug when unplug DC connector, please do not drag any wires in case of snap.
• Please use switch control to adjust the temperature of heating when hands feel not warm.
• Please do not wash the gloves in water directly. Please use brush or rag with water when gloves get dirty. Please use after air drying.
• Please stop using when the battery is bulging or have other abnormal phenomena.
• If you have problems sensing hot or cold objects (due to diabetes, Raynaud’s disease or similar) please consult your doctor before using these gloves.
• Check your hands regularly for reddening of the skin. Excessive heat levels over prolonged periods can lead to burns.
• Not for use by children
• Do not charge when wet.
• Do not insert any metal or other sharp object into the gloves, batteries, connecting sockets or plugs, as this could cause damage to the unit.
• Stop using the unit if you discover any damage to connecting cables, batteries or other parts. You may continue to use the glove without the heating system once the batteries have been removed.
• Batteries with a damaged protective film must no longer be used and must be disposed of immediately in a safe, environmentally-conscious manner.